Voltech AT360, User Manual

Page: 137 / 470

P
ROGRAM
E
DITOR
V
OLTECH
AT
I
U
SER
M
ANUAL
P
AGE
3-15
You may now set up any of the following options by simply clicking with the left
button of the mouse:
Results Printing
Printed reports may be obtained from the printer port of the tester as follows:
There will be no results printed out during the test execution.
Failures Only
The results of the tests producing a ‘fail’ result will
be printed.
Full Reporting
The results for all the tests in the program will be
printed out for each transformer tested.
Operator Numbering
During program execution, the operator will be
prompted to enter his or her identity code. All
results will then be tagged with this code.
Batch Numbering
During program execution, the operator will be
prompted to enter a batch number, which will be
attached to the test results.
Serial Numbering
During program execution, the operator will be
prompted to enter a serial number for each
transformer. The number will then be attached to
the results for the next transformer tested.
Send Results to Server
Select this option if you wish to have the tester
send all the measurement results back to the
Server PC for archive or analysis.
Send Retry Results to
Server
Enable this function if you wish the Server to
contain the results from the additional
measurements associated with re-running a
program, for example after execution has been
halted by the STOP ON FAIL program option.
Stop on Fail
Select this option to give the fastest test
throughput. During program execution, only
transformers that produce a ‘pass’ result will be
fully tested; failures will be rejected at the earliest
opportunity.