Voltech AT360, User Manual

Page: 140 / 470

P
ROGRAM EDITOR
P
AGE
3-18 V
OLTECH
AT
I
U
SER
M
ANUAL
An example of this display for an inductance test is shown below.
From this display, after you have pressed the CONTINUE softkey, the tester
will execute the remaining tests in the program, and the transformer will be
recorded as a fail. (If any further tests fail, then there will be another display
similar to the one above for each failing test.)
If you simply wish to throw away the failing transformer at the earliest
opportunity, then press the ABORT softkey to terminate this program run, and
return to the RUN-FINISH display, from where you can start the program again
for the next transformer in the batch.
Alternatively, you may use the RE-RUN softkey if, for example, the failure is
due to the fact that the transformer is not correctly inserted in the test fixture.
In this case, program execution starts again, and the transformer will receive a
‘pass’, if the only fault was that it had been wrongly inserted at the first attempt.
Vertical bar
– Represents
the value measured
Box
– Represents the user
programmable limits for the
test