Preparing to Cut: Turning on the Power
3 - 7
3.4 Turning on the Power
1
Make sure that the power switch is turned off (the " " side is pressed down).
2
Connect one end of the provided power cord to the Vinyl Express AC line inlet
and the other end to an electrical socket of the rated supply voltage. Make sure
that the Vinyl Express is grounded.
3
Turn on the Vinyl Express by pressing the "|" side of the switch. The control
panel POWER lamp lights.
4
If media has not been loaded, the firmware version number is displayed, fol-
lowed by a prompt to load media.
(The initial feed speed setting, interface settings and other parameter settings
can be made here).
LOAD MEDIA!
INITIAL MENU>
Summary of Contents for Q100
