38
11. Using the Printer
11.1 Setting up the Printer
(1) Set “Interface” to [
] using “9. Functions of Function 1” (page 30) as a reference.
(2) Set the print function (print control) to Balance Control by referring to the instruction manual of
the printer. The printer was set to Manual Print (Printer Control) at the factory prior to its
shipment.
(3) Check the settings of the balance and those of the printer, including the baud rate.
11.2 Printing in Compliance with ISO/GLP/GMP
(1) For the printer, use the CSP-160.
(2) Check the time and date of the balance. (See “6. Date and Time Setup” on page 13.)
* The year will be printed in 4 digits.
* Do not press any keys on the printer during printing.
11.3 Recording Calibration Results
(1) Set the Print Control of the printer to the balance side.
(2) Refer to “9. Functions of Function 1” (page 30) and verify that the item “Compliance with
ISO/GLP/GMP” is set to Enable([
]) and the item “Output of Calibration Result”
to Output Result([
]).
(3) Conduct the ordinary span adjustment or span test. (See “7. Calibration of Balance” on page
15.) The result is output (printed).
