29
2. Addition when a total value exceeds the capacity
(1)
/
○
→0←
NET
g
(2)
○
NET
g
↓
M
↓
○
NET Σ
g
↓
(3)
Measured
sample unloaded
○
g
(4)
/
○
NET
g
↓
(5)
○
NET
g
↓
M
↓
○
NET Σ
g
↓
(6)
○
g
(7)
/
○
NET Σ
g
Total value displayed
(1) Press the Zero/Tare key to reset the indication to
zero. Follow the same procedure when a container
is used. When [NET] lights up at the upper right,
the balance is now ready for addition. When the light
comes on, load a sample.
(2) Load a sample on the balance and press the Set
key. After [M] begins flashing, [NET
Σ
] lights up at
the upper right of the display. At the same time, the
balance shows the total value for about 4 seconds
and then goes back to the current weight.
(3) Unload the measured sample.
(4) Press the Zero/Tare key to reset a zero-point.
(5) Load a next sample and press the Set key. As
in (2), the balance displays the total value for about
4 seconds and, then goes back to the current
weight. Repeat steps (3) through (5) to perform an
addition function.
(6) Displaying the total value
Press the Function key. The balance displays
the total value while [NET
Σ
] lights up at the upper
right of the display. Pressing the Function key
again displays the current weight.
(7) Clearing the total value
While the total value is displayed, press the
Zero/Tare key. The indication is reset to zero
and the total value is cleared. Press the
Function key to return to the weight indication.
Cautions:
1. The adding operation will not be effective unless
the indication is reset to zero.
2. The
[
] indication appears when you
press the Set key in the case where you
have made a double adding operation, made a
negative addition, or added a zero.
Weight indication
restored
○
NET Σ
g
Total value cleared
8.9 Density Mode
Density measurement for solid and liquid is possible by using an optional density kit. For the
procedure, read the operation manual of the density kit.
