VeEX MTX150x Lite, User Manual

Page: 79 / 148

79 © VeEX Inc. All Rights Reserved. Platform Functions
Attach the DI-1000/DI-1000MPO/DI-3000
Attach one end of the OTG cable (not provided) to the microUSB port on the test set and the other end to the
fiberscope USB port.
Attach the fiberscope to an available USB Type-A interface on the test set.
If using a DI-3000, WiFi can be used to connect to a platform with WiFi available. See below.
When the DI-1000, DI-1000MPO, or DI-3000 are powered, they will emit a blue LED. Select the tip that best
matches the connector endface that is to be inspected.
For more information about available connector tips, see the DI-1000 Digital Fiber Inspection Microscope
Adapter Tips Guide on
www.veexinc.com .
After powering on and setting up the fiberscope, select the tip that best matches the connector endface that is
to be inspected.
Scope tips are secured in place with a locknut. There is a slot (specialty tips may have more than one slot) that
will ensure the tip is aligned properly to the top of the fiberscope prior to securing the locknut. Attach a tip by
rotating the locknut clockwise (tip faced away). Remove a tip by rotating the locknut counterclockwise (tip
faced away). With the correct tip fastened and secured, launch the Fiberizer application (PC, mobile, VeEX test
set) and plug into an available USB interface or
connect to the WiFi network .
Rotate the round focus knob to manually bring the image into focus. For the DI-3000 scope, a built-in autofocus
button can also be used.
Once the fiberscope is detected, tap Yes in the pop-up window to enter the Fiberscope menu.
Fiber Scope Detected Message
Alternatively, select > Platform Tools > Fiber Scope .