MUS0920201
07/10/2014 52
MELTON, S.L.U. - POLIGONO INDUSTRIAL AGUSTINOS CALLE G-34,31160 ORCOYEN, NAVARRA
TEL: 00 34 948 321580 Fax: 00 34 948 326584 e-mail: [email protected]
Filling the Tank:
Before filling the tank, put on goggles, gloves and a long-sleeve
shirt to prevent possible burns caused by hot adhesive
splashing.
Make sure that the tank is clean and free of foreign particles.
Fill the heated tank with the hot
–melt material up to a maximum of 10 mm below
the edge of the tank.
Close the cover of the tank immediately after filling it.
Note: Never operate the applicator if the tank is empty. If the
quantity of hot
–melt material is very small, the tank may overheat
leading to the carbonisation of the hot-melt material and the
formation of deposits inside the unit. This may lead to
unnecessary downtimes later on.
Filling the tank Isomelt buffer:
In this case the installation fills the tank automatically (see chapter 4.11 ISOMELT
BUFFER on page 49)