![background image](http://html1.mh-extra.com/html/valco-melton/isomelt/isomelt_user-manual_849620086.webp)
MUS0920201
07/10/2014 81
MELTON, S.L.U. - POLIGONO INDUSTRIAL AGUSTINOS CALLE G-34,31160 ORCOYEN, NAVARRA
TEL: 00 34 948 321580 Fax: 00 34 948 326584 e-mail: [email protected]
WARNING: The operations described in this chapter should be
performed by qualified personnel, following safety instructions.
A.2.2 INSTALLATION REQUIREMENTS
In order for the machine to work properly, there needs to be a 0-24VDC signal to
activate the solenoid valve and a compressed air circuit.
Avoid extreme room temperatures (below -10ºC and above +50ºC).
A.2.3. MECHANICAL INSTALLATION
WARNING: The installation operations indicated in this chapter
must only be done by qualified personnel who understand the
steps to take and are familiar with all safety measures.
This chapter outlines the procedures for installing the unit properly. Following
these procedures will ensure safe operation and a long useful life of the unit. Carefully
read Chapter 1: Safety before starting any installation process.
Before beginning, verify that the operator is duly protected and all safety measures
are being followed.
Make sure the regulation system air intake is positioned after the
air depressurisation valve on the main pneumatic installation or
make sure the electrovalve activation signal is connected to the
safety line on the main machine.
1 Cut off the air.
2 Disconnect the general switch.
3 Protect the general switch with the key to
prevent accidental connections.
4 Verify there is no power.
5 Verify there is no pressure in the adhesive;
bleed if necessary.
6 Operate following the applicable safety
instructions.