![background image](http://html1.mh-extra.com/html/valco-melton/isomelt/isomelt_user-manual_849620061.webp)
MUS0920201
07/10/2014 56
MELTON, S.L.U. - POLIGONO INDUSTRIAL AGUSTINOS CALLE G-34,31160 ORCOYEN, NAVARRA
TEL: 00 34 948 321580 Fax: 00 34 948 326584 e-mail: [email protected]
WARNING: The maintenance operations indicated in this chapter
must only be done by qualified personnel who understand the
steps to take and are familiar with all safety measures.
To apply the appropriate torque when assembling any part of the
machine, please check the torque instructions in Annex B.
6.1. INTRODUCTION:
This chapter outlines the procedures for proper maintenance of the ISOMELT
machine. Following these procedures will ensure safe operation and a long useful life of
the machine. Carefully read Chapter 1: Safety before starting any maintenance process.
General recommendations for proper maintenance:
Keep the tank as full of adhesive as possible. This will reduce the formation
of soot on the tank’s inner walls.
Keep the tank cover closed. (Any contamination in the tank will increase
the possibility of low performance. Humidity, dirt and sooty adhesive are
the main causes of injector obstruction).
Use a cheesecloth to remove material leaking from the joints and other
connectors when the machine is hot, but not in operation.
Completely empty and clean the system when there are frequent
obstructions due to dirt and soot.
Before beginning, verify that the operator is duly protected and all safety measures
are being followed.
1º
Switch off the air at the mains.
2º
Switch off the main switch.
3º
Lock the main switch in place.
4º
Make sure the electricity is off.
5º
Follow applicable safety and health standards.
6º