![background image](http://html1.mh-extra.com/html/valco-melton/d-90/d-90_manual_849616087.webp)
6-2
ValcoMelton
Section 6 - Operation
MM125 - D-90 Hot Melt Unit
Unit Startup - Continued
1.
If the power disconnect switch is on but there is nothing on the
display, the unit is in Standby mode. Push the Standby key on
the control and ensure the LED changes from orange to green.
Figure 6-2. Temperature Controller Important Operation Keys
1.
Set the temperatures of all of the connected heating zones
(collector, grid, manifold, filter block, hose etc.) See Section 5 –
Setup for details on how to adjust the temperature values.
2.
Wait for the system to heat up and for the system ready LED to
illuminate.
WARNING!
WARNING!
WARNING!
WARNING!
WARNING!
Hot surfaces! Do not touch unless necessary! Use
caution while performing the operation procedures in the
following sections. Wear protective gloves and goggles
at all times. OTHERWISE, SERIOUS PERSONAL
INJURY OR EQUIPMENT DAMAGE COULD OCCUR.
Collector
Grid
Filter Block
Summary of Contents for D-90
