![background image](http://html1.mh-extra.com/html/valco-melton/d-90/d-90_manual_849616089.webp)
6-4
ValcoMelton
Section 6 - Operation
MM125 - D-90 Hot Melt Unit
WARNING!
WARNING!
WARNING!
WARNING!
WARNING!
Make sure all heating zones are at the correct
temperature. The Pump Ready light should be on.
Make sure all hoses and fittings/connections are
secured properly to prevent adhesive leaks.
1.
Turn the pump on by pressing the Pump On/Off Key.
This may occur automatically if the
Automatic Pump Enable setting is
turned on. Refer to
Section 5 - Setup
for details.
The pump will operate only when the following conditions are met:
•
All of the heating zones are at the setpoint temperature.
•
The Pump clearance delay time has passed
•
The pump-enable jumper, or customer input is connected
properly
•
The pump is set to Manual or Automatic, as needed
2.
Adjust the motor speed if necessary (refer to
Section 5 - Setup for
details).
Dispensing
Adhesive
Summary of Contents for D-90
