VALCO MELTON D-90, Manual

Page: 76 / 150

5-37 Valco Cincinnati, Inc.
Section 5 – Setup MM125 - D-90 Hot Melt Unit
Configuration
The Configuration Menu contains screens that allow the user to setup global
parameters for the hot melt control. These configurations are shown below.
The number of hoses is used to set the control for how many hose/gun pairs
are being used by the operator. This setting would be set at the factory before
shipment.
Number of Hose
Outlets
An Auxiliary I/O board (151XX661) can be ordered separately as an option to
allow the operator to use four more user inputs and outputs. Once the board
is installed, the Auxiliary I/O must be enabled. The factory default setting is
“Disabled”. See Section 4 – Installation for Auxiliary I/O board connector. This
parameter can be accessed in Password Level 2 or higher (see Appendix A
Password Level).
When the Auxiliary I/O is set to “Enabled”, the additional programmable
inputs and outputs (5-8) will be activated.
When the Auxiliary I/O is set to “Disabled”, the additional programmable
inputs and outputs (5-8) will be deactivated.
Auxiliary I/O