VALCO MELTON D-90, Manual

Page: 82 / 150

5-43 Valco Cincinnati, Inc.
Section 5 – Setup MM125 - D-90 Hot Melt Unit
To restore the factory default settings, follow these steps:
CAUTION! CAUTION! CAUTION! CAUTION! CAUTION! Restoring the factory default settings will permanently
erase changes made to any parameter or setting!
1. Switch off power to the unit.
2. Power the unit back up while pressing and holding the Setup
Button and the OK Button on the keypad. The buttons can be
released once the start-up screen appears.
Restoring
Factory
Default
Settings
Initialize
Screen
The Init or Initialize Screen is used to reset ALL of the control parameters
back to the factory settings. When “OK” is selected to Initialize ALL Data, the
set up wizard will take the user through the control initialization to reconfigure
the hot melt control as if it were a brand new installation. From this point, the
user will be able to select number of hose / gun pairs, piston or gear pump,
etc.