Urschel COMITROL 2100, Instruction Manual

Page: 8 / 166

Addendum A.6
Manual Page Number Revision
28-29 Operation, Start-up, Stopping and Feeding: The following applies to the
electrical system supplied from approximately October 2009 until September
2018. See the previous pages for the starting and stopping procedures for
the current electrical system.
The top reset button is labeled
MASTER RESET
(1) . If the emergency
stop button (2)
was previously pushed,
the button must be reset in order to start
the machine; rotate and pull out to reset.
Allow the machine to reach full
operating speed, approximately ten
seconds, before feeding product. This
allows the motor for the feed screw to
reach the full programmed speed.
1
2