Setup
26
Document Number 206465-0001
User Guide
C. Enter the dynamic IP address for your printer (from step 2B) in the appropriate field.
D. Select the appropriate printer type from the drop down list.
E. Click
Add Printer
and close the
3D Printer
pop-up window.
F.
If you get an
“Error: Unable to connect to printer”
message it may be that your PC is not
configured for dynamic networking. To configure your PC for dynamic networking:
i.
From the
Control Panel
of your PC, double click on
Network and Internet Connections
.
ii.
Double click on
Network Connections
, then double click on
Local Area Connection
.
iii. Scroll the
Local Area Network Connection Properties
window to find the
Internet Protocol
(TCP/IP)
selection. Click on
Internet Protocol (TCP/IP)
and then click on the
Properties
button.
iv. From the
General
tab of the
Internet Protocol (TCP/IP)
properties pop-up window, click on
the
Obtain IP Address Automatically
radio button.
v.
Click
OK
and then
OK
again.
vi. After allowing your PC a minute or so to adjust to the new setting, your PC should connect to
your printer.
vii. If you are still unable to connect to your printer, recheck your connections and settings.
System Software
The system software is factory loaded on the printer. Due to occasional changes you may need to update
the printer system software.
Updating system software:
1. From the uPrint display panel, press
Maintenance
.
2.
Press
System
.
3.
Press
Load Upgrade
. The printer will then display
“Send upgrade from workstation”
followed by
the printer’s IP address.
4.
Open CatalystEX and click on the
Printer Services
tab.
5.
Click on the
Update Software
button. CatalystEX will now connect to the printer and will prompt you to
locate the upgrade file. Navigate CatalystEX to the CD where the upgrade file is located. The update
will automatically be loaded on to the printer. After the update has been loaded, the display will show
Verifying update
.
6.
When verification is complete, the display will show
Reboot to complete
. Select
Yes
. The printer will
now reboot and return to
Idle
.
7.
Press the maintenance button and verify the updated version was installed correctly.
Summary of Contents for 180-00108 uPrint
Page 1: ...User Guide...
