Setup
18
Document Number 206465-0001
User Guide
Inserting a modeling base
The modeling base is the plastic tray on which models are built. You will need to use a new modeling base
for every build.
1. Make sure the two retainers are turned down so they do not interfere with modeling base installation.
2.
Set the modeling base on the Z platform aligning the tabs on the modeling base with the slots on the
metal tray. See
Figure 12.
3.
Slide the modeling base down and toward the back of the unit until its front edge (with the handle) is
flush with the front edge of the tray. See
Figure 12.
4.
Secure the modeling base with the two retainers by turning them up. See
Figure 12
.
Figure 12: Z platform slots
Align tabs with slots
Summary of Contents for 180-00108 uPrint
Page 1: ...User Guide...
