Operation
43
Document Number 206465-0001
User Guide
Emptying the purge bucket
Empty the purge bucket after each build to avoid part quality issues or damage to the printer.
1. With a gloved hand, lift up on the purge bucket and pull it off of the two mounts. See
Figure 33
Figure 33: Emptying the purge bucket
2.
Empty the purge bucket.
3.
Place the purge bucket over the two mounts and push down to lock in place.
Replacing material for single material bay
1. From the display panel press
Material...
The display will show
Add/Remove
and
S1(remaining%)
and
M1(remaining%)
. Asterisks will mark the currently active material bays (the material bays that are
currently loaded to the head).
2.
Press
Unload...
3.
Select
Unload both
,
Unload Model
or
Unload Support
.
4.
The printer will now unload material from the head. When the material has unloaded, you will need to
replace the material carriers.
5.
Place the carrier on a flat stable surface.
WARNING
Wear gloves when emptying the purge bucket.
CAUTION
When reinstalling the purge bucket, make sure that it locks on both mounts
and hangs flush with the chamber wall to avoid damage.
Purge bucket
Purge bucket mounts
Summary of Contents for 180-00108 uPrint
Page 1: ...User Guide...
