Troubleshooting and Maintenance
54
Document Number 206465-0001
User Guide
Clogged extrusion tip
Occasionally, an extrusion tip may clog with material. This is often accompanied by a loss of extrusion
(LOE). A clogged tip will prohibit material load and part building.
Note:
It is recommended that you read and understand this entire
procedure before performing any of the work.
This procedure assumes that material is loaded to the
extrusion tip. If material has not been loaded, see
“Adding
material carriers to single material bay” on page 29
or
“Adding material carriers to the dual material bays” on
page 30
To clear a clogged extrusion tip:
1. From the display panel press
Maintenance
.
2.
Press
Machine
.
3.
Press
Head
.
4.
Remove the head cover by pressing the tabs in and pulling away from the head. See
Figure 41
Figure 41: Remove the head cover
5.
Remove the air plenum by pressing the tabs in and pulling away from the head. See
Figure 42
Press tab in to remove head
cover
Summary of Contents for 180-00108 uPrint
Page 1: ...User Guide...
