Troubleshooting and Maintenance
56
Document Number 206465-0001
User Guide
Figure 44: Create access space for cleaning - model side shown
7.
Move the toggle bar to ‘deactivate’ the clogged tip.
Note:
Push the toggle bar to the right to deactivate the support
side. Push the toggle bar to the left to deactivate the model
side.
8.
Snip the material just after it passes between the drive wheel and the idler wheel (‘pinch point’).
Note:
If necessary manually pull more material forward in order to
reach the ‘pinch point’.
9.
Move the toggle bar to activate the clogged side. This will make the drive wheel control options active
for the clogged side.
Note:
Push the toggle bar to the left to activate the support side;
push the toggle bar to the right to activate the model side.
10. Press
Forward
on the interface panel. The drive wheel will turn, but material will not feed because the
idler wheel is held out of position.
Summary of Contents for 180-00108 uPrint
Page 1: ...User Guide...
