Operation
44
Document Number 206465-0001
User Guide
6.
Open the carrier.
7.
Rotate the spool to rewind the material, leaving 2 inches (50mm) remaining at the filament guide. See
Figure 34
Figure 34: Rewinding the material spool
8.
Using a cutters, cut the excess 2 inches (50mm) of material from the filament guide. leaving a blunt
end.
9.
Replace the material spool.
10. Close and latch the carrier.
11. Once the material carriers have been replaced press
Load...
12. Select
Load Model,
Load Support
or
Load both
.
13. After material has been loaded to the head press
Done...
Replacing material for dual material bays
1. From the display panel press
Material...
The display will show
Add/Remove
and
S1%,
S2
(remaining%) and
M1, M2
(remaining%). Asterisks will mark the currently active material bays (the
material bays that are currently loaded to the head).
2.
Press
Unload...
3.
Press
Unload both
,
Unload Model
or
Unload Support
.
4.
The printer will now unload material from the head. When the material has unloaded, you will need to
replace the material carriers.
5.
Place the carrier on a flat stable surface.
CAUTION
Do not push the material through the filament guide back into the carrier,
doing so can cause material to break or become tangled.
Rewind the material back onto
the material spool
Summary of Contents for 180-00108 uPrint
Page 1: ...User Guide...
