Operation
45
Document Number 206465-0001
User Guide
6.
Open the carrier.
7.
Rotate the spool to rewind the material, leaving 2 inches (50mm) remaining at the filament guide. See
Figure 35
Figure 35: Rewinding the material spool
8.
Using a cutters, cut the excess 2 inches (50mm) of material from the filament guide, leaving a blunt
end.
9.
Replace the material spool.
10. Close and latch the carrier.
11. Once the material carriers have been replaced press
Load...
12. You can select which carriers you want to load to the head by selecting
Next Model
or
Next Support
.
When done selecting press
Load Selected
.
13. The printer will now load the selected material bays and prepare the other bays for automatic loading.
After they are done loading and preparing, press
Done...
the display will show
Wait for Part
or
Ready
to Build
.
Material bay LEDs
The table below will show the status indicated by the LEDs.
CAUTION
Do not push the material through the filament guide back into the carrier,
doing so can cause material to break or become tangled.
On
●
Material currently loaded to the head
Off
○
No carrier present
Carrier present and ready to be loaded
Blinking
☼
Carrier needs replacement (is empty or has an error)
Rewind the material back onto
the material spool
Summary of Contents for 180-00108 uPrint
Page 1: ...User Guide...
