Chapter 13: Alarm and event setup
TruVision NVR 22 (SP) User Manual
113
Option
Description
This port number must match the port number set up in the
intrusion panel.
Set up the heartbeat alarm parameters:
7.
Enable Panel Heartbeat
Alarm
Select this check box to enable the panel heartbeat alarm.
The heartbeat alarm will then be reported to the recorder.
8.
Heartbeat Interval (s)
Enter the interval between two heartbeats. It is measured in
seconds. Default is 120 s. This interval is valid even if the
“Enable Panel Heartbeat Alarm” check box is disabled.
To be able to trigger a heartbeat alarm when the heartbeat is
not received within this interval, enable the “Enable Panel
Heartbeat Alarm” check box.
The recorder heartbeat interval must always be higher than
that of the intrusion panel.
Actions
Click the
button to set up the actions linked to the panel
heartbeat alarm. Go to step 3.
Set up the panel arming event parameters:
10. Enable Panel Arming
Event
Select this check box to enable the panel arming event. When
the panel is armed, it will be reported to the recorder.
11. Actions
Click the
button to set up the actions linked to the panel
arming event. Go to step 3.
Set up the panel disarming alarm parameters:
12. Enable Panel Disarming
Alarm
Select this check box to enable the panel disarming event.
When the panel is disarmed, it will be reported to the
recorder.
13. Actions
Click the
button to set up the actions linked to the panel
disarming alarm. Go to step 3.
14. Disable Actions
Select this checkbox to enable the execution of event/alarm
actions and to influence the recording behavior. Default is
Disabled.
See “Disable actions” on page 119 for further information.
3. To define the actions for the heartbeat, panel arm and panel disarm alarms that are
reported by the intrusion panel, click
Action
and each of the tabs:
Trigger Channel:
Select the cameras that will be recorded when an alarm event is
received. The cameras will be recorded following the main stream
(alarm) parameters. The recordings will be 10 seconds for each
assigned camera.
