TX6000 Series Operation Manual Ver1.4
10
Chapter 3
Introduction to [DISP]
3.1
<MEAS DISPLAY>
When the LCR function is applied, press [DISP], the <MEAS DISPLAY> page will
be displayed on screen as shown in the following figure.
On this page, the test result is displayed in upper-case character. The
measurement control parameters can be set on this page:
Test function (FUNC)
Test frequency (FREQ)
Test level (LEVEL)
Test range (RANGE)
DC BIAS (BIAS)
Test speed (SPEED)
There are 6 zones in this page: FUNC, FREQ, LEVEL, RANG, BIAS and SPEED.
The details will be discussed later.
The test result/ condition display zone shows the information about test condition.
These conditions can be set on <MEAS SETUP> page or <CORRECTION> page.
Signal source voltage/ current monitor (Vm, Im)
Open, short, load correction ON/OFF status (CORR)
3.1.1
Test function
In a measurement period, TX6000 series can test two parameters for an
impedance component: one primary parameter and one secondary parameter.
Parameters that can be tested are as follows:
