TX6000 Series Operation Manual Ver1.4
22
Operation steps for setting the list sweep mode:
Set the sweep mode on the <LIST SWEEP DISP> page as SEQ or STEP.
1)
On the < LIST SWEEP DISP > page, move the cursor to the MODE zone,
the following soft keys will be displayed:
SEQ
STEP
2)
Press SEQ to set the sweep mode as sequential sweep test mode.
3)
Press STEP to set the sweep mode as single step sweep test mode.
3.4.2
FREQ (Hz)
This zone shows the currently swept parameter mode and its unit. What are right
below this item are parameters of the sweep list.
3.4.3
R[:] X[:]
This zone is the currently swept Function parameter and its unit. What are right
below this item are the sweep results.
3.4.4
CMP (Compare)
This zone indicates the compare results of the currently swept points. L means
the result is lower than the standard and H is higher than the standard, while
blank is medium.
3.5
<MEASURE SETUP>
Press [SETUP] to enter into the <MEASURE SETUP> page shown as below:
