TX6000 Series Operation Manual Ver1.4
5
numerical keys [0] to [9], decimal point [.] and [
+/-
] key.
(NOTE: long press [.] key is equivalent to copying screen function)
6)
[KEYLOCK]
Press [KEYLOCK], it will be lighted, which means the function of current panel
is locked. Press it again, it will be off, which means discharging the lock status.
If the password function is ON, it means correct password is necessary when
discharging the key-lock, or the key cannot be unlocked.
When the instrument is controlled by RS232, [KEYLOCK] will be lighted. Press
[KEYLOCK] again, it will be off, which means returning to the local
discharging lock status.
7)
[BIAS]
[BIAS] is used to permit or forbid the output of 0-50mA/5V DC bias source.
Press this key, it will be lighted which means DC bias output is permitted.
Press this key once more, it will be off which means DC bias output is
prohibited. The key is useless in some pages where the DC BIAS cannot be
added. (No this function in TX6000 series). When the FUNC is set as DCR,
Lp-Rd, Ls-Rd, this function is invalid.
8)
PASS/FAIL indicator
PASS LED indicator shows the test result has passed.
FAIL LED indicator shows the test result has failed.
9)
USB HOST interface
Connect U flash disk so as to save or load the file.
10)
[RESET]
Press this key to stop scanning only in transformer automatic scanning. No
operation will be executed on other pages.
11)
[TRIGGER]
When the trigger mode is set to MAN mode, press this key to trigger the
instrument.
12)
Test terminals (UNKNOWN)
4-teminal test pair is used to connect 4-terminal test fixture or cable to
measure DUT.
The 4 terminals are respectively as follows: Hcur, Hpot, Lpot and Lcur.
13)
LCD
480*272 colorful TFT LCD displays measurement results and conditions.
14)
Soft keys
