Epic 3000
Programmer’s Guide
Programming Codes
100-14362
Rev A
Page 25
Error Vector Taken
4 Blinks
On
Off
Knife Error
5 Blinks
On
Off
Flash File system Error
6 Blinks
On
Off
User Store Fault
7 Blinks
On
Off
Configuration Fault
8 Blinks
On
Off
Flash Read/Write Error
9 Blinks
On
Off
Dynamic Memory
Allocation
10 Blinks
On
Off
Font system Fault
11 Blinks
On
Off
Static Memory Allocation
12 Blinks
On
Off
Communications Fault
14 Blinks
On
Off
Kernel Fault
15 Blinks
On
Off
Head Connection Fault
16 Blinks
On
Off
USB Fault
17 Blinks
On
Off
Power Saving Modes
Sleep
In Sleep mode, the EPIC 3000 printer enters a low power state where everything but the
communications is disabled. In this mode, the printer may be reactivated by command
or by pressing the Power Button. As the print head preheat is turned off, it may take a
few seconds for the EPIC 3000 to warm up the print head in preparation for printing.
This mode is activated by command only. (See page 238)
Green/Standby
In Green mode, the EPIC 3000 printer enters a lower power state where everything
including the communications is disabled. The printer will enter and leave Green mode
based on the Vbus signal on the USB link. This allows the printer to enter a low power
state whenever the USB link is placed in a low power state.
The operational state of the EPIC 3000 can be determined by looking at the Power
Indicator Light (LED). When the printer enters ON mode, the green power indicator light
will be activated. When in Sleep mode, the Power Indicator Light (LED) will blink about
every 3 seconds. In Green mode, the Power Indicator Light (LED) will blink about every
5 seconds.
