T480 Unicode and Fonts
T480
Programmer’s Guide
Page
210
Rev A
100-14362
The following table lists the commands and how they interact.
Command
Zero
Character
width
Character
height
Cell Width
Pseudo Fixed
pitch flag
[ESC] + P,
[ESC] + p
Width 0
Same as
Height
From
command
From Font
No effect
[ESC] + P,
[ESC] + p
Width
Not Zero
From
Command
From
command
Based on
set character
spacing
command
Will be used if
previously set
and character
spacing is not
being defined
by the font
[ESC] + I,
[ESC] + i
Value 0
No effect
No effect
From Font
Set Off but has
no effect
[ESC] + I,
[ESC] + i
Value
Not zero
No effect
No effect
From
Command
Set Off
[ESC] + J,
[ESC] + j
Value 0
No effect
No effect
From Font
Set On but has
no effect
[ESC] + J,
[ESC] + j
Value
Not zero
No effect
No effect
A multiple of
the value
defined by the
command
Set On
[ESC]I <n>
From
POR.INI
definition
From
POR.INI
definition
As defined by
command
Will be used if
previously set.
Function
Set minimum character height and width in points.
All
ASCII
[ESC] + P <w><h>
Hexadecimal
1BH 2BH 50H
Decimal
<27> <43> <80>
Range
w = 0, 4
– 72 h = 4 - 72
The [ESC] + P command will set the minimum character width or height based on “w” for
the width and “h” for height, where “w” and “h” are in points, defined as 1/72
nd
of an inch
increments.
If the character width is set to zero, the height will be used for the width and proportional
spacing will be used.
NOTE:
The set pitch command will take precedence unless this command
selects 0 width.
