Epic 3000
Programmer’s Guide
Programming Codes
100-14362
Rev A
Page 23
Verify the Firmware Configuration
An example receipt is Included in the box your printer shipped in that will show how the
printer was configured before it shipped from our Ithaca facility. Compare this
information to your system requirements. Pay attention to the emulation and the
communications link. If they are wrong, the printer may appear inoperative. If the
configuration is not correct, refer to the section on changing the EPIC 3000
configuration. If there are a number of printers to be installed and you want the identical
configuration in each, you can use the universal configuration program to record the
configuration on one printer, and replicate it over a group. The configuration program is
available from Transact technical support.
Installing Paper
It is easy to install paper in the EPIC 3000.
1. Open the paper cover by grasping the cover release between your thumb and
forefinger, and squeeze the release. This will pop the cover up.
2. Open the cover and install a roll of paper with the paper coming off of the bottom
of the roll.
3. Lay the paper tail over the front of the printer and center it over the paper path.
4. Close the cover. When the cover is closed, the printer will feed several inches of
paper to make sure the paper is aligned in the printer. If equipped with a cutter,
the printer will automatically cut the paper tail and the printer is now ready to
print. If the printer is not equipped with a cutter, the operator should remove the
paper tail.
