Programming Codes
Epic 3000 Programmer’s Guide
Page
22
Rev A
100-14362
Buzzer
A buzzer is provided as a standard feature. It is triggered upon command from the host
terminal to make a sound loud enough to be heard under noisy conditions. It will produce
a sound pressure level of at least 90 dBA, 1 foot from the front of the printer.
Cover Interlock
A paper cover interlock switch is provided as a standard feature. When the paper cover
is open, the printer is off-line, and will not print.
Communications Interface
All EPIC 3000
’s are equipped with a USB 2.0 interface.
USB Interface
The USB interface is a Version 2.0 High or Full Speed implementation. The USB
interface is standard on all printers and implemented through a Standard Series "B"
Receptacle as defined in the USB Specification. The printer is self-powered and does
not draw power from the standard type B USB interface cable.
The Standard USB Type B connector has the following pin functions:
Pin Signal
1 Vbus (+5 V dc)
2 Minus data
3 Plus data
4 Ground
Note:
The +5 power on the standard USB interface does not have enough
power to run the printer.
Setup
Verifying the Configuration
Before you install an EPIC 3000 Printer into your system, you should verify that the
printer is configured as required by your system. There are four parts to this verification
process.
1. Verify that the power connection is correct.
2. Verify that the firmware in the printer is configured correctly.
Connecting Communications Cables
The EPIC 3000is USB only.
