TrangoLINK Apex™ 18 User Manual Rev. 1.0 Section: Appendix A - Command Set Summary Page 73
status
Display status for different device and ports
sync_state
Display current synchronization state
sysinfo
Display system information
syslog
Display system event log
targetrssi
Display target rssi value
telnetd
Display telnet daemon (telnetd) status
temp
Display current system temperature
tftpd
Display tftp server (tftpd) status
trapip
Display SNMP Trap IP configuration
uptime
Display system uptime
utype
Display unit type
version
Display system software version
Config Mode
Users can enter this mode by typing in the command “config” from the view mode. They
will be prompted for a password and after successful authentication users enters the
config mode. All configuration settings can be changed here.
•
All the commands entered without any parameters returns the current configured
values and are similar to “view” mode.
•
All configuration changes are applied immediately and don’t require any reboot
(except “speed” in which the settings are applied immediately, but it does require
reboot after save).
•
All configuration changes have to be saved in order to be persistent across
reboot. A single “save” command will save all configuration changes
•
Users can go back to the “view” mode by typing in the command exit
Command List in Config Mode
CLI Ranges
Default
Value
acm
<mod>
N/A
enable on/off
Off
mse_de <mse value>
Depending on modulation
mse_im <mse value>
Depending on modulation
alignment_mode
on/off Off
atpc
on/off Off
atpc_max_power
0-20 17
atpc_step
<1-4> dB
1dB
