TrangoLINK Apex™ 18 User Manual Rev. 1.0 Section: Appendix A - Command Set Summary Page 98
SUCCESS
RELATED
Show passwords, config
Port (ge1 = Copper / ge2 = Fiber)
SYNTAX
port <eth > <port#> <settings> <value>
For Ethernet Port the following commands are valid
port eth <ge1|ge2> <autonegotiate> <on|off>
port eth <ge1|ge2> <duplex> <on|off>
port eth <ge1|ge2> <enable> <on|off>
port eth <ge1|ge2> <rate> <0-1000Mbps>
port eth <ge1|ge2> <pause> <on| off>
port eth <ge1|ge2> <priority> <0-3>
port eth <ge1|ge2> <speed> <10 | 100 |1000>
DEFAULT VALUE
For GigE copper and fiber Ports the default settings are
Autonegotiate: ON
Duplex: Full
Enable: ON
Rate: 1000Mbps
Pause: OFF
Priority: 0
Speed: 1000Mbps
For TDM ports the default settings are
Enable: ON
Loopback: OFF
DESCRIPTION
Port command is used to set the GigE copper and fiber
ports
EXAMPLE
To set ge1 speed 100Mbps
(trango-config)# port eth ge1 speed 100
Port ge1 speed 100
SUCCESS
To set the ingress rate limit on ge2 to 160Mbps
(trango-config)# port eth ge2 ingress 160
Port ge2 Max rate: 160 Mbps
