TrangoLINK Apex™ 18 User Manual Rev. 1.0 Section: Chapter 3 - Configuration
Page 35
Httpd:
Enable or disable the HTML daemon. This must be enabled to have web
access to the unit.
Opmode:
Opmode is short for operation mode. When opmode is enabled the unit will
be transmit RF. If opmode is disabled the unit can still be managed but the RF portion of
the device will be disabled.
!
NOTE: DO NOT ENABLE OPMODE UNTIL THE TRANSMIT FREQUENCY HAS BEEN
SET TO THE LICENSED FREQUENCY
RSSI LED:
The RSSI digital display can be enabled or disabled.
Telnetd:
Enable or disable the Telnet daemon. This must be enabled for telnet
access.
!
NOTE: SSH access to the unit can not be enabled or disabled. This is intentional in the
product design.
Ethernet Configuration
Port Link:
The option of enabling or disabling the specified port.
Auto Nego:
Enable or disable auto negotiation of the specified port.
Pause Frame:
Enable or disable the use of pause frames on the specified port.
Duplex:
Set the duplex setting of the specified port. Auto Negotiation must be disabled
and speed setting must be specified. Only Full duplex is allowed on the Fiber port.
Priority:
Set the priority of the specified port over remaining ports.
Speed:
Set the negotiation speed of the specified port. Auto Negotiation must be
disabled and duplex setting must be specified. Only 1000Mbps is allowed for Fiber port.
Ingress Rate:
The Ingress Rate sets the maximum bandwidth of traffic that can pass
through the specified port.
Statistics Page
The Statistics page will display the status of the following areas: System, Link, Ethernet,
and RF (Figure 11).
