TrangoLINK Apex™ 18 User Manual Rev. 1.0 Section: Chapter 2 - Getting Started
Page 24
!
ALL CONFIGURATION CHANGES HAVE TO BE SAVED IN ORDER TO BE
PERSISTENT ACROSS REBOOT. A SINGLE “SAVE” COMMAND IN THE
CLI WILL SAVE ALL CONFIGURATION CHANGES.
Users can go back to the “view” Mode by typing in the command “
exit
”
Example:
trango login: admin
Password:
Trango Broadband Wireless: TrangoLink APEX Command Line Interface v1.0
(trango-view)# config
Password:
(trango-config)# exit
(trango-view)#
The Command Line Interfaces keeps a history of commands used, pressing the up
arrow will display previous commands used. The CLI can complete a command being
typed by pressing <tab> key. If a command is partially typed followed immediately by a
“?” it will display all related commands.
Example:
(trango-config)# t?
targetrssi Displays target rssi value
temp Displays IDU and ODU temperature
tftpd Displays tftp server (tftpd) status
threshold Set the threshold for the radio parameters
trapip Displays SNMP Trap IP configuration
(trango-config)#
!
TYPE “?” FOR A LISTING OF ALL CLI COMMANDS
.
Changing Password
The debug and config mode share the same password. The view mode has a separate
password. The config mode password is changed in the config mode. Use the CLI
command password to change the password. The example below demonstrates
changing the password for the config mode to “control”
Syntax: password <
newpassword
>
Example:
(trango-config)# password control
(trango-config)# password
