Toyota RAV4 (RHD) - MMC, Owner'S Manual

Page: 171 / 646

170 3-2. Opening, closing and locking the doors
tion)
Antennas inside the cabin
■ Effective range (areas within which
the electronic key is detected)
When locking or unlocking the doors
The system can be operated when the
electronic key is within about 0.7 m (2.3
ft.) of either of the outside front door
handles and back door opener switch.
(Only the doors detecting the key can be
operated.)
When starting the engine or chang-
ing engine switch modes
The system can be operated when the
electronic key is inside the vehicle.
■ If an alarm sounds or a warning
message is displayed
An alarm sounds and warning message
displays shown on the multi-information
display are used to protect against
unexpected accidents or theft of the
vehicle resulting from erroneous opera-
tion. When a warning message is dis-
played, take appropriate measures
based on the displayed message.
When only an alarm sounds, circum-
stances and correction procedures are
as follows.
● When an exterior alarm sounds once
for 5 seconds
●
When an interior alarm pings continu-
ously
■
Battery-saving function (vehicles
with entry function)
The battery-saving function will be acti-
vated in order to prevent the electronic
key battery and the battery from being
discharged while the vehicle is not in
operation for a long time.
● In the following situations, the smart
entry & start system may take some
time to unlock the doors.
• The electronic key has been left in an
area of approximately 2 m (6 ft.) of the
outside of the vehicle for 10 minutes
or longer.
• The smart entry & start system has
not been used for 5 days or longer.
● If the smart entry & start system has
not been used for 14 days or longer,
the doors cannot be unlocked at any
doors except the driver’s door. In this
case, take hold of the driver’s door
handle, or use the wireless remote
control or the mechanical key, to
unlock the doors.
C
A
B
Situation
Correction proce-
dure
An attempt was
made to lock the
vehicle while a
door was open.
Close all of the
doors and lock the
doors again.
Situation
Correction proce-
dure
The engine switch
was turned to ACC
while the driver’s
door was open (or
the driver’s door
was opened while
the engine switch
was in ACC).
Turn the engine
switch to OFF and
close the driver’s
door.