Toyota RAV4 (RHD) - MMC, Owner'S Manual

Page: 334 / 646

333
4
4-5. Using the driving support systems
D
riv
ing
■ The Parking Support Brake func-
tion (static object) will operate
when
The function will operate when the
PKSB OFF indicator is not illuminated or
flashing (

P.96, 97) and all of the fol-
lowing conditions are met:
● Engine output restriction control
• The Parking Support Brake is
enabled.
• The vehicle speed is 15 km/h (9 mph)
or less.
• There is a static object in the traveling
direction of the vehicle and 2 to 4 m (6
to 13 ft.) away.
• The Parking Support Brake deter-
mines that a stronger-than-normal
brake operation is necessary to avoid
WARNING
● Do not replace a sensor with a part
other than a genuine part.
● Do not subject a sensor or its sur-
rounding area to a strong impact.
● Do not damage the sensors, and
always keep them clean.
● If the area around a radar sensor is
subjected to an impact, the system
may not operate properly due to a
sensor malfunction. Have the vehi-
cle inspected by your Toyota dealer.
■ Handling the suspension
Do not modify the suspension, as
changes to the height or inclination of
the vehicle may prevent the sensors
from detecting objects correctly or
cause the system to not operate or
operate unnecessarily.
■ If the Parking Support Brake
function (static objects) oper-
ates unnecessarily, such as at a
railroad crossing
In the event that the Parking Support
Brake function (static objects) oper-
ates unnecessarily, such as at a rail-
road crossing, brake control will be
canceled after approximately 2 sec-
onds, allowing you to proceed forward
and leave the area, brake control can
also be canceled by depressing the
brake pedal. Depressing the acceler-
ator pedal after brake control is can-
celed will allow you to proceed
forward and leave the area.
■ Notes when washing the vehicle
Do not apply intensive bursts of water
or steam to the sensor area.
Doing so may result in the sensor
malfunctioning.
● When using a high pressure
washer to wash the vehicle, do not
spray the sensors directly, as doing
so may cause a sensor to malfunc-
tion.
●
When using steam to clean the
vehicle, do not direct steam too
close to the sensors as doing so
may cause a sensor to malfunction.
■ When to disable the Parking Sup-
port Brake
In the following situations, disable the
Parking Support Brake as the system
may operate even though there is no
possibility of a collision.
● When inspecting the vehicle using
a chassis roller, chassis dynamo or
free roller
●
When loading the vehicle onto a
boat, truck or other transport vessel
● If the suspension has been modi-
fied or tires of a size other than
specified are installed
● If the front of the vehicle is raised or
lowered due to the carried load
● When equipment that may obstruct
a sensor is installed, such as a tow-
ing eyelet, bumper protector (an
additional trim strip, etc.), bicycle
carrier, or snow plow
● When using an automatic car wash