32861AA
93
PAN /TILT / ZOOM OVERVIEW
The PTZ controls within the recorder allow you to control PTZ cameras without accessing them directly. This can increase the usefulness
of your recorded video. Using the PTZ controls, you can create custom preset configurations that can continuously sweep across large
areas.
Note
These instructions are for use with Analog PTZ cameras only. For IP PTZ cameras, please refer to the PTZ Camera Setup
section of this manual.
Note
PTZ setup and control is only available for supported video encoders with a PTZ RS-485 pass-through.
Basic PTZ Configuration
1.
On the Live screen, click
Setup
, and then click
PTZ
Setup
.
2.
Select a PTZ-enabled camera from the
Select
Channel
list.
3.
Select
Enable Pan Tilt Connection
.
4.
Click
Select Protocol
and select the appropriate
protocol for your PTZ camera. For information on the
protocol used by your PTZ camera, refer to your
camera manual.
5.
Set the appropriate
Port
,
Baud Rate
,
Parity
,
Data
Bits
, and
Stop Bits
. These settings must match those
of your PTZ camera. For more information, refer to
your camera manual.
6.
Click
Apply
to save your settings.
