50
Etc.
Additional motion detection configuration options are found on the Etc. tab. Use this tab to set a camera channel to appear at full screen
in the Display screen when a motion or sensor event is detected. You can also set your recorder to enable motion detection even during
continuous recording, or play an audio warning when an alarm event is detected.
Note
It is not recommended to enable Full Screen Pop Up on Motion for all channels (either manually, or by clicking
Apply to All
Channels
). This will cause performance problems.
Set a camera channel
to be immediately
displayed full screen
Enable motion
detection during
continuous recording
Enable an audio
warning during an
alarm event
Set to record a single image at a
specified interval (1 sec ~ 24 hr)
