Toshiba Strata CIX GVPH, Programming Manual, Page: 162 / 184

Maintenance and Troubleshooting
Tools
8-10
Strata CIX40 Voice Processing Programming Manual 7/06
System Integration Patterns
If your telephone system supports integration, this selection controls the definition of its
integration. Perform this step only to refine, verify, or modify the integration of the Stratagy
system with your telephone system.
Some of the pre-defined telephone system dial codes already contain integration information,
while others are configurable.
Define the System Integration Pattern Fields
1. From the Tools menu, press
4
. The Telephone System Configuration screen displays.
2. From the Telephone
System Configuration
screen, press
2
. The
System Integration
Patterns screen displays
(shown right).
3. Define Integration Timeout
by 1/10—amount of time
Stratagy waits for
integration information
from the telephone system.
Possible values:
0
~
99
(disable integration) (in
10ths of seconds).
Suggested value: 30 (30 10ths = 3 seconds)
4. Define the remaining fields (i.e., integration strings) that Stratagy should match.
Proceed to “Define the Integration Strings Stratagy Matches” on page 1-11 .
5. After making the change(s), press
ESC
. The Telephone System Configuration screen
displays.
6. From the Telephone System Configuration screen, press
1
. The changes are
transmitted to Stratagy and Stratagy is shut down and restarted. By shutting down and
restarting Stratagy, the changes take effect.
...or
2
.The changes are transmitted to Stratagy but Stratagy is not shut down or
restarted. Until you restart Stratagy, the changes do not take effect.
...or
3
. The changes you made are cancelled and not saved.
7. If you pressed
1
to save the changes, press any key to reboot. The DOS prompt
displays. To continue, you must re-enter Stratagy Admin.
Modify Integration Patterns
1. From the Tools menu, press
4
. The Telephone System Configuration screen displays.
2. From the Telephone System Configuration screen, press
2
. The System Integration
Patterns screen displays.
3. From the System Integration Patterns screen, use the arrow keys (
↑↓
)
...or
Page Up
and
Page Down
to highlight the integration pattern parameter. Press
Enter
.
4. Modify the integration pattern using the line editor at the top of the screen.