Toshiba Strata CIX GVPH, Programming Manual, Page: 161 / 184

Maintenance and Troubleshooting
Tools
Strata CIX40 Voice Processing Programming Manual 7/06
8-9
Ma
in
ten
a
nc
e a
nd
T
rou
bl
esh
o
o
ti
ng
# Number of seconds to wait for dialtone detection:
The longest amount of time Stratagy waits for the telephone system to give Stratagy one second of dial tone.
Setting this value to a number greater than zero enables Stratagy’s dial tone detection.
If your telephone system has a limited number of DTMF receivers or intercom paths for call transfers, there is
always the possibility that one may not be available to Stratagy to perform a call transfer.
Typical value:
4
- No change required
# Number of 1/100 seconds to use for Flash time:
Time Stratagy must remain on-hook while performing a hookflash.
Typical value:
55
(just over one-half second) - No change required
# Which DTMF tone to listen to for answer detection:
Some telephone systems play a specific DTMF tone during a call transfer when the called extension answers. This
provides faster answer detection and call processing. If your telephone system supports this feature, enter the
DTMF tone.
Typical value:
a
- No change required
# Which DTMF tone to listen to for hangup detection:
Some telephone systems play a specific DTMF tone whenever a caller hangs up. This provides faster hang up
detection and call processing. If your telephone system supports this feature, enter the DTMF tone.
Typical value:
d
- No change required
# What to dial before dialing the User ID extension:
The code Stratagy dials after dial tone detection and before dialing the extension number.
Typical value: left blank - No change required
# What to dial after dialing the User ID extension:
Code Stratagy dials after dialing the extension number.
Some applications use
1-
to eliminate (system wide) voice announce during a call transfer by Stratagy
(necessary if you want Stratagy to perform supervised transfers). Use H to force all call transfers to be blind, or
unsupervised.
# What to dial when the system first starts up:
Initialization codes Stratagy dials when it first starts-up, e.g., removing call forwarding on the Stratagy ports.
Not Applicable
# What to dial when the system performs a shutdown:
Codes Stratagy dials when it shuts down; e.g., enabling call forwarding on the Stratagy ports.
Not Applicable
# What to dial when a port goes off-hook:
Codes Stratagy dials whenever it goes off-hook to enable a special feature, such as special types of serial, or
RS-232, integrations.
Not Applicable
Table 8-2 Telephone System Dial Codes - Definitions and Settings (continued)
Parameter/Description