Toshiba e-studio 2555c, Troubleshooting Manual

Page: 74 / 136

1 TROUBLESHOOTING FOR THE HARDWARE
72 When Printed Sheets Overflow from the Exit Tray
When Printed Sheets Overflow from the Exit Tray
When thin, small size paper (A4-R/LT-R or smaller) is used, the end of the sheets may get stuck in the exit
tray walls. If 300 or more sheets are printed under such condition, some printed sheets may be pushed out of
the exit tray.
In the case above, installing the paper exit stopper at the designated location of the exit tray will increase the
amount of recommended plain paper that can be loaded on to the exit tray to about 500 sheets.
y
When printing a large number of large size sheets such as A3 and A4/LD and LG, place the paper exit
stopper back in its original location.
y When the finisher or inner tray is installed in the equipment, use the paper exit stopper installed in its
original location.
Removing the paper exit stopper from its original location
Installing the paper exit stopper in the designated location for improving paper exit
Placing the paper exit stopper back in its original location
1
Remove the paper exit stopper from the groove on the exit tray while pushing its
fulcrum inward.
1
Unfold the paper exit stopper located on the left of the
exit tray and remove it from its groove while pushing
the fulcrum inward.
1
Turn the tip of the paper exit stopper to the left and
insert the paper exit stopper fulcrum into the groove
on the exit tray.
2
Install the paper exit stopper in the groove on the left
of the exit tray.