Tieline Bridge-IT XTRA, User Manual

Page: 96 / 209

96 Bridge-IT XTRA Manual
© Tieline Pty. Ltd. 2015
16.8
Configuring SIP Programs
SIP programs are like a normal IP program to configure, with two small differences; entering a SIP
address and selecting SIP as the
Session Protocol .
Important Notes: Before you start program configuration please note:
· SIP can only operate using the LAN / ETHERNET port on the rear panel of the codec.
· You cannot edit a program when it is currently loaded in the codec.
· Some drop-down menus and settings may be greyed out intentionally depending on
features available.
· To learn more about programs see the section titled About Program Dialing .
1. Open the web-GUI and click the Programs symbol at the top of the screen to display the
Programs panel .
2. Click the New Program button to open the wizard and:
· Click in the Program Name text box to name the new program.
·
Select Mono/Stereo Peer to Peer, or if you want to use an existing program as a template,
select this option. Then click Next .
Important Notes: When you choose to use an existing program as a template, the new
program inherits all the settings of the template program and you can adjust these settings
as required by continuing through the program wizard.
3. Enter a name for the Audio Stream and configure the codec to dial, answer or dial and
answer. Then click Next .
Note: The following example will display how to configure a dial and answer program. If you want the
codec to either dial or answer only, select the option and the wizard will automatically display
screens to allow you to configure the codec correctly.
4. This audio stream connection in the wizard will allow the codec to dial. Enter the name of the
connection in the text box, then click Next .