Tieline Bridge-IT XTRA, User Manual

Page: 26 / 209

26 Bridge-IT XTRA Manual
© Tieline Pty. Ltd. 2015
9 Configuring AES3 Audio
If your input source is AES3 (AES/EBU) format use the IN1/AES3 IN input on the rear panel of the
codec. This is a balanced 110 ohm female XLR input and can operate effectively over distances of up
to 100 meters. The input accepts both mono and stereo AES3 signals as only a single 3 pin XLR
input or output is required for sending and receiving two channels of AES3 data. To configure the
codec to accept AES3 data signals:
1. Press the SETTINGS button.
2. Navigate to Audio and press .
3. Select Input Type and press the button to toggle from Analog to AES/EBU .
The 3 pin male XLR AES3 output on the rear panel is labeled AES3 OUT . It is capable of sending
both mono and stereo AES3 signals.
Important Note: Input levels are set at 100% automatically for AES3 connections. If you
switch back to the analog input setting after selecting AES3, the previous analog settings
will be recovered.
AES/EBU Sample Rate Conversion
The codec implements an Asynchronous Sample Rate Converter (ASRC) to convert the sample rate
of the AES3 input to the sample rate set in the codec. The codec sample rate is determined by the
selected algorithm. For example, if you select the Music algorithm, the sample rate will be set to
32kHz when the codec is connected.
The codec accepts AES3 input sample rates of 32kHz, 44.1kHz or 48kHz. The output sample rate
is determined by the algorithm used when connected.
AES3 Audio Out & SD Card Sample Rate
1. When you are not connected, you can adjust the AES3 output sample rate manually in the
Audio menu via the AES3 SR setting.
2. If file playback occurs before a connection is initiated, the AES3 output sample rate will match
the audio file sample rate.
3. For best performance, the SD card file sample rate should match the AES3 SR setting in the
codec and the algorithm sample rate. If they don't match, the codec will re-sample the SD card
file audio to match the connection sample rate, and this will be used by the AES3 output. For
example, if you are streaming audio using Tieline Music (32kHz sampling), file playback will be
re-sampled to 32kHz if the SD card file is 44.1kHz or 48kHz. In this example the AES3 output
sample rate will be 32kHz.
Adjusting the Codec Output Sample Rate
As there is no external reference clock for the codec it is necessary to set the output sample rate of
the codec when you are not connected. The
AES3 SR setting in the Audio menu will configure
audio outputs and audio monitoring, as well as SD card playback at this sample rate. The default
setting is 48kHz sampling: