6.
Manual operation
5-11
5. Operations and
adjustment
TSC
6-1
Manual operation
In function mode 1, the actuator can be operated discretionarily by external input and output, in
addition to normal positioning operation.
* Operations are allowed even before zero return, but the servo must be ON.
There are the jog operation in which the actuator operates during the input is ON, and inching
operation in which the actuator moves for a certain distance and then stops per each turning
ON.
Turning the JOG/INCHING input (pin.10) ON will activate the inching operation, and OFF will acti-
vate the jog operation.
①
Jog operation: Only while being ON, the actuator in operates in positive (+) direction with JOG
P (pin.11), or in negative (-) direction with JOG N (pin.12).
For definitions of positive and negative directions, see "
4-2 Positive/negative of moving
direction(
→
P.5-9)
".
The moving speed is set by the parameter No.21 (I/O jog speed).
This moving speed is common to that of the inching operation described below.
②
Inching operation: Once turned ON, the actuator in moves for certain distance in positive (+)
direction with JOG P (pin.11), or in negative (-) direction with JOG N (pin.12).
For definitions of positive and negative directions, see "
4-2 Positive/negative of moving
direction(
→
P.5-9)
".
The moving speed is set by the parameter No.21 (I/O jog speed).
This moving speed is common to that of the jog operation described above.
The moving distance is set by the parameter No.22 (I/O inching distance).
To repeat the operation, turn it OFF and then ON.
Summary of Contents for TSC Series
Page 98: ...MEMO ...