1-5
1. Introduction
2.
Safety precautions
TSC
2-3
Safety precautions
While the actuator is operating or
operable, do not enter the working
area of any moving part including
the load.
Doing so may cause you to touch the
moving part and get injured.
If the product fails or any abnor-
mality is observed, shut down the
power of the driver controller TSC.
Such abnormality may cause a mal-
function of actuator, resulting in dam-
age or injury.
Do not touch the internal part of
the driver controller TSC.
Doing so may cause electric shocks.
Do not damage, tuck, or apply ex-
cessive stresses on the cable.
Doing so may cause electric shocks.
Do not modify, disassemble, or al-
ter the product.
Doing so may cause injury or fault.
During the operation, or for a while
after turning the power off, do not
touch the driver controller TSC,
motor or motor cover because
they should be hot.
Doing so may cause burns.
Prohibited
Obligatory
Caution -
Electrical shock
Do not
disassemble
Caution – High
temperature
Do not impact the product and
do avoid rough handling such as
throwing it.
Doing so may cause the fault or dam-
age that leads to injury.
Do not frequently switch the power
between on and off.
Doing so may generate heat from the
internal parts of the driver controller
TSC, which results in fault or burns.
Do not set the speed or accelera-
tion setting or place the load on the
actuator that exceed the actuator
specification.
Doing so may cause motor failure,
which leads to unexpected accidents
or damages.
If an alarm is generated, remove
the cause, check the safety, de-
activate the alarm, and restart the
operation. (
→
P.6-5)
Failure to do so may result in failure,
which leads to injury.
Use this product with a combina-
tion that is specified beforehand.
Failure to do so may cause fire or fault.
Observe the specified input volt-
age.
Failure to do so may cause fire or fault.
Prohibited
Obligatory
Caution –
Flammable
WARNING
CAUTION
Summary of Contents for TSC Series
Page 98: ...MEMO ...
