Thermo King SLXi Spectrum, Maintenance Manual

Page: 302 / 342

Structural Maintenance 12-44
Reassembly
1. Coat the outer edges of the oil seal with gasket sealant.
2. Using a suitable tool, slightly smaller than the outside diameter of bearing races, install the bearing races in the bearing
housings.
3. Using a soft or wooden hammer, install the seals in the bearing housing and bearing housing cap. Fill the space between the
seal lips with oil.
4. Lubricate the roller bearings with oil by rolling it in the palm of your hand, making sure oil fully penetrates the bearings.
5. Using a suitable tool slightly larger than the bearing shaft, tap bearings onto the shaft until the bearings are seated on the
bearing shaft.
6. Install the shaft into the housing and assemble the remaining bearing race, shims, O-ring, and bearing housing cap on the
bearing house. Torque bolts to 13.5 N•m.
7. Check the end play with a dial indicator. Add or remove shims until end play is between 0.025 to 0.127 mm.
8. Remove the fill plug and the oil level plug.
9. Fill the oil reservoir through the fill plug hole until oil starts to come out of the oil level plug hole.
10. Install the oil level plug and the fill plug.
Jackshaft Assembly – SL
1. Oil Fill Plug
2. Vent
3. Oil Level Plug