Structural Maintenance
12-31
3. Slide the fan shaft (item 5) into the control box side condenser blower area. Place the control box side condenser orifice (item
2) around the fan shaft. Then slide the control box side condenser blower (item 4) over the compressor side end of the fan
shaft.
4. Slide the fan shaft through both seal plates (item 10) and the hole in the bulkhead. When the fan shaft enters the evaporator
section, slide the evaporator shaft seal collar (item 13) over the compressor side end of the fan shaft. The rubber gasket on the
collar should face toward the control box side of the unit so it will contact the seal plate when it is adjusted properly.
Install Evaporator Shaft Seal Collar and Orifice –
SL, SLe, SMX and SMX-II
1.
Evaporator Shaft Seal Collar (item 13)
2.
Control Box Side Evaporator Orifice (item 8)
Evaporator Blower Orientation (Control Box Side
View) – SL and SLe
1.
Condenser Side
2.
Orient Blower Wheel Blades as Shown
3.
Evaporator Side
Summary of Contents for SLXi Spectrum
