Telestream PRISM MPI, User Manual

Page: 37 / 304

Getting Started
SFP Module Installation
37
PRISM MPI-MPX User Manual
SFP Module Installation
There are several types of optional SFP modules available:
•
"SD/HD/3G-SDI optical transmitter
•
"SD/HD/3G-SDI DIN transmitter
•
"SD/HD/3G-SDI HD-BNC transmitter
•
"10G Ethernet short range transceiver (850 nm)
•
"10G Ethernet long range transceiver (1310 nm)
Note:
ST2022-7 requires two 10GE SFP modules to be installed. The modules must be
installed in SFP ports 1 and 2.
MPX and MPI SFP Module Installation
To install an SFP module on an MPX or MPI monitor, insert the SFP module into the SFP
connector. The module latches into place when fully inserted.
Note: There are different types of SFP modules for 10GE signals. If the SFP module
does not match the unit signal setting (for example, a 25GE SFP module is installed),
the Link Status (in Network, under Settings) returns “SFP Error.”
To remove the SFP module, pull the latch down or up as according to the SFP and then
pull the module out of the SFP connector.
Note:
To ensure you are using the correct SFP connectors, the 10GE and SDI SFP
connectors are marked on the back of the MPI (see
MPI Rear Panel Connectors
) and
MPX (see
MPX Rear Panel Connectors
). Different types of SFP modules may have
different latching mechanisms.
SFP Module Transportation
Caution: To prevent static damage to the SFP module, if you remove the SFP
module from the instrument, always transport the SFP module in an anti-static
bag or container.
Caution: To prevent possible damage to the PRISM monitor and SFP modules,
remove the SFP modules before transporting the PRISM monitor.