Telestream PRISM MPI, User Manual

Page: 33 / 304

Getting Started
MPI Power-on and Power-off Procedures
33
PRISM MPI-MPX User Manual
MPI Power Cord Removal
The power cord housing latches on the instrument power connector when fully
inserted. To remove the power cord, grasp the connector housing, as shown, and firmly
pull the cord away from the instrument.
Caution: To prevent damage to the power cord or to the instrument power
connector, do not attempt to disconnect the power cord by pulling on the cable.
You must pull on the connector housing to disengage the locking mechanism.
To minimize the risk of damage to the instrument, it is strongly recommended that the
power cord be disconnected from the AC power source before the power cord is
disconnected from the instrument.
MPI Power-on Procedure
1. Apply power to the instrument. (See
MPI Power Cord Installation
.)
Note: If the PRISM monitor was previously powered off by a power interruption or by
removing the power cord from the rear of the instrument, the instrument powers on
when power is reapplied.
2. Press the Power/Standby button on the instrument front panel to turn the
instrument on.