Models 707B and 708B Switching Matrix Reference Manual
Section 2: General operation
707B-901-01 Rev. B / January 2015
2-73
The settings that are affected are:
•
Channels and patterns are removed from the scan list
•
Bypass: Returned to default setting of ON
•
Mode: Returned to default setting of Open All
•
Scan count: Returned to default setting of
1
•
Trigger to start scan: Set to Immediate
•
Trigger to continue channel action for each scan step: Setting is cleared
•
Arm (Scan Start Stimulus) is set to None
•
Channel Action Stimulus is set to Channel Ready Event
•
Channel Ready Event is set to None
•
Scan Complete Even is set to None
To reset the scan list from the web interface:
1. From the left navigation of the web interface Home page, select Scan Builder.
2. Click
Scan & Trigger Reset
.
Run the scan
You can run a scan in one of several ways:
•
Background:
Runs the scan in the background so that you can perform other tasks while the scan is
running. You can use the Query State to check scan status.
•
Step by Step:
Steps through the scan.
To run the scan as a background scan from the web interface:
Click
Execute Background
or
Step by Step
.
Stop the scan
To stop the scan from the web interface:
On the Build & Run tab, click
Abort
.
Monitor the state of the scan
To monitor the state of the scan, you can click
Query State
on the Build & Run tab.
Query State
displays the current state of the scan, which can be:
•
Empty: No scan defined
•
Building: Scan list is being created
•
Running: Scan in process
•
Success: Scan completed successfully
Set up simple triggers
You can set up triggers to control your scan using the options on the Simple Trigger tab. You can set:
•
The event that starts the scan
•
The time interval event that controls the channel action for each step of the scan
To see these options, click the
Simple Trigger
tab from the top of the Scan Builder page.