Section 7: TSP command reference
Models 707B and 708B Switching Matrix Reference Manual
7-116
707B-901-01 Rev. B / January 2015
Details
This attribute specifies which event causes a LAN trigger packet to be sent for this trigger. Set
triggerStimulus
to one of the existing trigger event IDs shown in the following table.
Trigger event IDs
Trigger event ID
Description
digio.trigger[N].EVENT_ID
An edge (rising, falling, or either based on the
configuration of the line) on the digital input line.
display.trigger.EVENT_ID
The trigger key on the front panel is pressed.
trigger.EVENT_ID
A
*trg
message on the active command interface. If
GPIB is the active command interface, a GET
message also generates this event.
trigger.blender[N].EVENT_ID
A combination of events has occurred.
trigger.timer[N].EVENT_ID
A delay expired.
tsplink.trigger[N].EVENT_ID
An edge (rising, falling, or either based on the
configuration of the line) on the TSP-Link trigger line.
lan.trigger[N].EVENT_ID
A LAN trigger event has occurred.
scan.trigger.EVENT_SCAN_READY
A Scan Ready Event has occurred.
scan.trigger.EVENT_SCAN_START
A Scan Start Event has occurred.
scan.trigger.EVENT_CHANNEL_READY
A Channel Ready Event has occurred.
scan.trigger.EVENT_SCAN_COMP
A Scan Complete Event has occurred.
scan.trigger.EVENT_IDLE
An Idle Event has occurred.
Setting this attribute to zero disables automatic trigger generation.
If any events are detected prior to calling
lan.trigger[
N
].connect()
, the event is ignored and
the action overrun is set.
Example
lan.trigger[5].stimulus = trigger.timer[1].EVENT_ID
Use timer 1 trigger event as
the source for LAN packet 5
trigger stimulus.
Also see
(on page 7-108)
(on page 7-108)
(on page 7-109)
(on page 7-113)